Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER NO.1


3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C091925
  1. Remove the 18 bolts, oil pan and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan so that fluid remaining in the pan does not spill out.



    D030865
  1. Remove the 2 magnets from the oil pan.



    AT00103
  1. Examine particles in the pan.

    1. Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      Wear of the bearing, gear or plate
      Brass (non-magnetic):
      Wear of the bearing



5. DISCONNECT TRANSMISSION WIRE


    C091927E04
  1. Disconnect the 7 shift solenoid valve connectors.

  1. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.



6. REMOVE TRANSMISSION WIRE


    D030866
  1. Disconnect the transmission wire connector.

  1. Remove the bolt and transmission wire.

  1. Remove the O-ring from the transmission wire.