Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C091925
  1. Remove the 18 bolts, oil pan and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan so that the fluid remaining in the pan does not spill out.



    D030865
  1. Remove the 2 magnets from the oil pan.



    AT00103
  1. Examine particles in the pan.

    1. Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      Wear of the bearing, gear or plate
      Brass (non-magnetic):
      Wear of the bearing



5. DISCONNECT TRANSMISSION WIRE


    C091927E04
  1. Disconnect the 7 shift solenoid valve connectors.

  1. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.



6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C091931
  1. Remove the 3 bolts and oil strainer.

    NOTICE:
    Be careful when removing the oil strainer as fluid will come out.



    C091932
  1. Remove the O-ring from the valve body oil strainer assembly.



7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C091933
  1. Support the valve body assembly and remove the 17 bolts and the transmission valve body assembly.



    C050017
  1. Remove the check ball body and the spring.



    C089112
  1. Remove the bolt and lock plate from the valve body assembly.

  1. Remove the shift solenoid valve SL3 and SLT from the valve body assembly.



    D026442
  1. Remove the bolt and shift solenoid valve S4 from the valve body assembly.



    D026438
  1. Remove the shift solenoid valve SR from the valve body assembly.



    D026443
  1. Remove the bolt and shift solenoid valve DSL from the valve body assembly.



    C089113
  1. Remove the bolt and shift solenoid valve SL2 from the valve body assembly.



    C089115
  1. Remove the bolt and shift solenoid valve SL1 from the valve body assembly.