Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    58-10    Gyro Error

DTC    80-10    Gyro Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the gyro signal
  1. Gyro sensor
  1. Navigation receiver assembly
80-10
Ground short, power supply short, or open circuit in the gyro signal

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)


    E120088
  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. Check the gyro voltage.

    Standard voltage:
    0.1 to 4.5 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.RECHECK DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    HINT:
    If DTCs are detected frequently, replace the navigation receiver assembly.

    OK:
    Malfunction disappears.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK

END