DTC 01-D5 Absence of Registration Unit |
DTC 01-D8 No Response for Connection Check |
DTC 01-D9 Last Mode Error |
DTC 01-DA No Response Against ON / OFF Command |
DTC 01-DB Mode Status Error |
DTC 01-DE Slave Reset |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-D5 *1, *3 | A device that the sub-code shows is (was) disconnected from the system when turning the ignition switch to the ON or ACC position. The communication condition with the device that the code shows cannot be obtained when the engine starts. |
|
| 01-D8 *2, *3 | The device indicated by the sub-code is (was) disconnected from the system after the engine starts. | |
| 01-D9 *1, *3 | The device that had functioned before the engine stopped is (was) disconnected from the system when the ignition switch is (was) in the ON or ACC position. | |
| 01-DA *3 | No response is identified when changing mode. Sound and image do not change by switch operation. | |
| 01-DB *1, *3 | A dual alarm is detected. | |
| 01-DE *3, *4 | A slave device has been disconnected after the engine starts |
| 1.CHECK "RADIO RECEIVER COMMUNICATION ERROR" IN FLOW CHART |
| NEXT | ||
| ||