Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › FORWARD CLUTCH

FORWARD CLUTCH > DISASSEMBLY

for Preparation Click here



1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH

HINT:



2. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC


    D026753E01
  1. Using a screwdriver, remove the snap ring.



    D026754
  1. Remove the flange, 5 discs and 5 plates from the input shaft assembly.



3. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


    D026418E01
  1. Place SST on the spring retainer and compress the return spring with a press.

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring seat is lowered 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring seat from being deformed.
    2. Do not expand the snap ring excessively.



    D026709E02
  1. Remove the clutch balancer from the input shaft.



    D026708E01
  1. Remove the forward clutch return spring from the input shaft.



4. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


    D003664
  1. Place the forward clutch drum onto the oil pump.

  1. Holding the forward clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the oil pump to remove the forward clutch piston.

    HINT:
    When the piston cannot be removed as it is slanted, blow air again with the protruding side pushed, or remove the piston using the needle nose pliers with vinyl tape on the tip.



5. REMOVE INPUT SHAFT OIL SEAL RING


    C056374
  1. Remove the input shaft oil seal ring from the input shaft.