Home › ENGINE › 2GR-FE CHARGING › GENERATOR

GENERATOR > REPLACEMENT

for Preparation Click here



1. REPLACE GENERATOR DRIVE END FRAME BEARING


    A128076
  1. Remove the 4 screws and retainer plate from the drive end frame.



    A128077E01
  1. Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)



    A128081E01
  1. Using SST and a press, press in a new generator drive end frame bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)



    A137712E01
  1. Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.

  1. Install the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }