NAVIGATION SYSTEM > AVC-LAN Circuit |
| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the navigation receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R15-5) - ATX- (R15-15) | Always | 60 to 80 Ω |
| TXM+ (R14-9) - TXM- (R14-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR |
Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
Check for an open or short in all AVC-LAN circuits.

|
| ||||
| OK | ||
| ||