Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > REMOVAL

for Preparation Click here



1. DRAIN POWER STEERING FLUID


2. REMOVE FRONT WHEEL RH


3. REMOVE FRONT FENDER APRON SEAL RH


    A162371
  1. Remove the 2 bolts, clip and front fender apron seal RH.



4. REMOVE FAN AND GENERATOR V BELT


    A162386E01
  1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

    SST
    09249-63010  



    A095070
  1. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.



5. DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE


    C133174E02
  1. Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.



6. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    C161546
  1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.



7. DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR


    C161547
  1. Disconnect the power steering fluid pressure switch connector.



8. REMOVE VANE PUMP ASSEMBLY


    C158999E01
  1. Using SST, loosen bolt (A) and remove bolt (B), and then remove the vane pump assembly.

    SST
    09249-63010  



    C135238
  1. Remove the bolt from the vane pump assembly.