Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > DISASSEMBLY

for Preparation Click here



1. HOLD VANE PUMP ASSEMBLY


    C141305E01
  1. Using SST, hold the vane pump assembly in a vise.

    SST
    09630-00014   (09631-00132)



2. REMOVE POWER STEERING SUCTION PORT UNION


    C133179
  1. Remove the bolt and the power steering suction port union from the vane pump front housing.

  1. Using a screwdriver, remove the O-ring from the power steering suction port union.



3. REMOVE POWER STEERING FLUID PRESSURE SWITCH

NOTICE:
Perform this procedure only when the power steering fluid pressure switch is replaced.



    C133180
  1. Remove the power steering fluid pressure switch from the vane pump front housing.



4. REMOVE FLOW CONTROL VALVE ASSEMBLY


    C158998
  1. Remove the pressure port union from the vane pump front housing.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve assembly and the flow control valve compression spring from the vane pump front housing.



5. REMOVE VANE PUMP REAR HOUSING


    C107024
  1. Remove the 4 bolts and vane pump rear housing from the vane pump front housing.



    C107025E02
  1. Using a screwdriver, remove the O-ring from the vane pump rear housing.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE VANE PUMP SHAFT WITH PULLEY


    C057767
  1. Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft with pulley.

  1. Remove the vane pump shaft with pulley.



7. REMOVE VANE PUMP ROTOR


    C114697
  1. Remove the 10 vane pump plates.

  1. Remove the vane pump rotor.



8. REMOVE VANE PUMP CAM RING


    C114698
  1. Remove the vane pump cam ring from the vane pump front housing.



9. REMOVE VANE PUMP FRONT SIDE PLATE


    C114699
  1. Remove the vane pump front side plate from the vane pump front housing.



    C107029E02
  1. Using a screwdriver, remove the O-ring from the vane pump front side plate.

    HINT:
    Tape the screwdriver tip before use.



    C114700
  1. Remove the O-ring from the vane pump front housing.



10. REMOVE VANE PUMP HOUSING OIL SEAL


    C114701E02
  1. Using a screwdriver and a shop rag or a piece of cloth, remove the vane pump housing oil seal from the vane pump front housing.

    NOTICE:
    Be careful not to damage the vane pump front housing.