VANE PUMP > REASSEMBLY |
| 1. INSTALL VANE PUMP HOUSING OIL SEAL |
Coat a new vane pump housing oil seal lip with power steering fluid.
![]() |
Using SST and a press, install the vane pump housing oil seal until it is flush with the vane pump front housing end surface.
| 2. INSTALL VANE PUMP SHAFT WITH PULLEY |
![]() |
Coat the inside surface of the bushing in the vane pump front housing with power steering fluid.
Gradually insert the vane pump shaft with pulley.
| 3. INSTALL VANE PUMP FRONT SIDE PLATE |
![]() |
Coat a new O-ring with power steering fluid and install it into the vane pump front housing.
![]() |
Coat a new O-ring with power steering fluid and install it onto the vane pump front side plate.
![]() |
Align the notch of the vane pump front side plate with that of the vane pump front housing, and install the vane pump front side plate.
| 4. INSTALL VANE PUMP CAM RING |
![]() |
Align the notch of the cam ring with that of the vane pump front side plate, and install the vane pump cam ring with the inscribed mark facing upward.
| 5. INSTALL VANE PUMP ROTOR |
![]() |
Install the vane pump rotor.
Coat the 10 vane pump plates with power steering fluid.
![]() |
Install the vane pump plates with the round end facing outward.
| 6. INSTALL VANE PUMP SHAFT SNAP RING |
![]() |
Using a screwdriver and a snap ring expander, install a new vane pump shaft snap ring onto the vane pump shaft with pulley.
| 7. INSTALL VANE PUMP REAR HOUSING |
![]() |
Coat a new O-ring with power steering fluid and install it onto the vane pump rear housing.
![]() |
Align the straight pin of the vane pump rear housing with the notches of the vane pump cam ring, vane pump front side plate, and vane pump front housing.
![]() |
Install the vane pump rear housing to the vane pump front housing with the 4 bolts.
| 8. INSPECT TOTAL PRELOAD |
![]() |
Check that the pump rotates smoothly without abnormal noise.
Temporarily install the service bolt.
Using a torque wrench, check the pump rotating torque.
| 9. INSTALL FLOW CONTROL VALVE ASSEMBLY |
![]() |
Coat the flow control valve assembly with power steering fluid.
Install the flow control valve compression spring and the flow control valve assembly to the vane pump front housing.
Coat a new O-ring with power steering fluid and install it onto the pressure port union.
Install the pressure port union to the vane pump front housing.
| 10. INSTALL POWER STEERING FLUID PRESSURE SWITCH |
Coat the O-ring attached to the new power steering fluid pressure switch with power steering fluid.
![]() |
Install the power steering fluid pressure switch to the vane pump front housing.
| 11. INSTALL POWER STEERING SUCTION PORT UNION |
Coat a new O-ring with power steering fluid and install it to the power steering suction port union.
![]() |
Install the power steering suction port union to the vane pump front housing with the bolt.