ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION |
| 1. CHECK ACCELERATOR PEDAL ROD |
Check the voltage.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Operate the accelerator pedal, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.
| Accelerator Pedal Condition | Specified Condition |
| Released | 0.5 to 1.1 V |
| Depressed | 2.5 to 4.5 V |
| Accelerator Pedal Condition | Specified Condition |
| Released | 1.2 to 2.0 V |
| Depressed | 3.4 to 5.0 V |