CHARGING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK BATTERY ELECTROLYTE LEVEL |
Check the electrolyte level.
If the electrolyte level is low, replace the battery (or add distilled water) and check the charging system.
| 2. CHECK BATTERY SPECIFIC GRAVITY |
![]() |
Check the color of the hydrometer.
| Hydrometer Color | Condition |
| Green | Good |
| Dark | Charging necessary |
| Clear or Light Yellow | Replacement necessary |
| 3. CHECK BATTERY VOLTAGE |
Turn the ignition switch off and turn on the headlights for 20 to 30 seconds. This will remove the surface charge from the battery.
![]() |
Measure the battery voltage between the negative (-) and positive (+) terminals of the battery.
| 4. CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
If the terminals are corroded, clean them.
| 5. CHECK FUSES |
Measure the resistance of the ALT fuse, ALT-S fuse, GAUGE fuse and GAUGE 1 fuse.
| 6. CHECK V-RIBBED BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
| 7. INSPECT GENERATOR WIRING |
Visually check the generator wiring.
Check that the wiring is in good condition.
| 8. CHECK FOR ABNORMAL NOISES |
Listen for abnormal noises from the generator.
Check that no abnormal noises are heard from the generator while the engine is running.
| 9. CHECK CHARGE WARNING LIGHT CIRCUIT |
Turn the ignition switch to the ON position. Check that the charge warning light comes on.
Start the engine and check that the light goes off.
If the light does not operate as specified, troubleshoot the charge warning light circuit.
| 10. INSPECT CHARGING CIRCUIT WITHOUT LOAD |
![]() |
Connect a voltmeter and ammeter to the charging circuit as follows.
Disconnect the wire from terminal B of the generator, then connect it to the negative (-) lead of an ammeter.
Connect the positive (+) lead of the ammeter to terminal B of the generator.
Connect the positive (+) lead of a voltmeter to positive (+) terminal of the battery.
Ground the negative (-) lead of the voltmeter.
Check the charging circuit.
Keep the engine speed at 2000 rpm and check the reading on the ammeter and voltmeter.
| 11. INSPECT CHARGING CIRCUIT WITH LOAD |
Keep the engine speed at 2000 rpm, turn on the high beam headlights, and turn the heater blower switch to the "HI" position.
Check the reading on the ammeter.