DIRECT CLUTCH > DISASSEMBLY |
| 1. INSPECT PACK CLEARANCE OF REVERSE CLUTCH |
| 2. INSPECT PACK CLEARANCE OF DIRECT CLUTCH AND OVERDRIVE CLUTCH |
| 3. REMOVE DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Using a screwdriver, remove the snap ring from the intermediate shaft.
![]() |
Remove the flange, 3 discs, 3 plates and cushion plate from the intermediate shaft.
| 4. REMOVE OVERDRIVE DIRECT CLUTCH DISC |
![]() |
Using a screwdriver, remove the snap ring from the intermediate shaft.
Remove the flange, 4 discs and 4 plates from the intermediate shaft.
| 5. REMOVE OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place SST on the clutch balancer and compress the spring with a press.
Using a snap ring expander, remove the snap ring from the direct clutch drum.
![]() |
Remove the clutch balancer from the direct clutch drum.
![]() |
Remove the overdrive clutch return spring from the direct clutch drum.
| 6. REMOVE OVERDRIVE DIRECT CLUTCH PISTON |
![]() |
Install the intermediate shaft on the transaxle rear cover.
Holding the direct clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch piston.
| 7. REMOVE OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Holding the direct clutch drum by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch drum.
| 8. REMOVE OVERDRIVE DIRECT CLUTCH O-RING |
![]() |
Using a screwdriver, remove the O-ring from the direct clutch drum.