Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › DIRECT CLUTCH

DIRECT CLUTCH > DISASSEMBLY

for Preparation Click here



1. INSPECT PACK CLEARANCE OF REVERSE CLUTCH

HINT:



2. INSPECT PACK CLEARANCE OF DIRECT CLUTCH AND OVERDRIVE CLUTCH

HINT:



3. REMOVE DIRECT MULTIPLE DISC CLUTCH


    D026419E01
  1. Using a screwdriver, remove the snap ring from the intermediate shaft.



    D026420
  1. Remove the flange, 3 discs, 3 plates and cushion plate from the intermediate shaft.



4. REMOVE OVERDRIVE DIRECT CLUTCH DISC


    D026422
  1. Using a screwdriver, remove the snap ring from the intermediate shaft.

  1. Remove the flange, 4 discs and 4 plates from the intermediate shaft.



5. REMOVE OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


    D003677E01
  1. Place SST on the clutch balancer and compress the spring with a press.

    SST
    09387-00020  

  1. Using a snap ring expander, remove the snap ring from the direct clutch drum.

    NOTICE:
    1. Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
    2. This prevents the spring seat from being deformed.
    3. Do not expand the snap ring excessively.



    D026424E02
  1. Remove the clutch balancer from the direct clutch drum.



    D026423E04
  1. Remove the overdrive clutch return spring from the direct clutch drum.



6. REMOVE OVERDRIVE DIRECT CLUTCH PISTON


    D026463
  1. Install the intermediate shaft on the transaxle rear cover.

  1. Holding the direct clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch piston.



7. REMOVE OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY


    D026425
  1. Holding the direct clutch drum by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch drum.



8. REMOVE OVERDRIVE DIRECT CLUTCH O-RING


    D026464E01
  1. Using a screwdriver, remove the O-ring from the direct clutch drum.