DIRECT CLUTCH > REASSEMBLY |
| 1. INSTALL OVERDRIVE DIRECT CLUTCH O-RING |
![]() |
Coat an O-ring with ATF, and install it to the direct clutch drum.
| 2. INSTALL OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Coat the direct clutch drum with ATF, and install it to the intermediate shaft.
| 3. INSTALL OVERDRIVE DIRECT CLUTCH PISTON |
![]() |
Coat the overdrive direct clutch piston with ATF, and install it to the direct clutch drum.
| 4. INSTALL OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the overdrive clutch return spring to the direct clutch drum.
Coat the clutch balancer with ATF.
![]() |
Install the clutch balancer to the direct clutch drum.
![]() |
Place SST on the clutch balancer and compress the overdrive clutch return spring with a press.
Using a snap ring expander, install the snap ring to the direct clutch drum.
Be sure that the end gap of the snap ring is not aligned with the spring retainer claw.
![]() |
Set the end gap of the snap ring in the piston shown in the illustration.
| 5. INSTALL OVERDRIVE DIRECT CLUTCH DISC |
![]() |
Coat the 4 discs with ATF.
Install the 4 plates, 4 discs and flange to the intermediate shaft.
![]() |
Using a screwdriver, install the snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 6. INSTALL DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Coat the 3 disc with ATF.
Install the cushion plate, 3 plates, 3 disc and flange to the intermediate shaft.
![]() |
Using a screwdriver, install the snap ling.
Check that the end gap of the snap ling is not aligned with one of the cutouts.