Home › ENGINE › 2GR-FE COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A162365
  1. Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



2. REMOVE NO. 1 ENGINE UNDER COVER


    A162362
  1. Remove the 8 bolts, 4 clips and No. 1 engine under cover assembly.



3. DRAIN ENGINE COOLANT


  1. Loosen the radiator drain cock plug.


    A161473E01

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

    NOTICE:
    Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the 2 cylinder block drain cock plugs.



4. REMOVE FRONT WHEEL RH


5. REMOVE FRONT FENDER APRON SEAL RH


6. REMOVE V-RIBBED BELT


    A162386E01
  1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

    SST
    09249-63010  



    A095070
  1. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.



7. DISCONNECT NO. 2 RADIATOR HOSE


    A162797
  1. Disconnect the No. 2 radiator hose from the engine.



8. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A195782E01
  1. Remove the bolt, idler pulley cover plate, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.

    HINT:
    Plate diameter:
    Idler pulley cover plate: 33.6 mm (1.32 in.)
    No. 2 idler pulley cover plate: 37.8 mm (1.49 in.)



9. REMOVE WATER INLET


    A162796
  1. Remove the 2 nuts and water inlet.



10. REMOVE THERMOSTAT
  1. Remove the gasket from the thermostat.