DTC P0111 Intake Air Temperature Sensor Gradient Too High |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0111 |
| Mass air flow meter assembly |
| Related DTCs | P0111: Intake air temperature sensor rationality (Stuck) |
| Required Sensors / Components (Main) | Intake Air Temperature (IAT) sensor |
| Required Sensors / Components (Sub) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 5 hours |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Time after engine start | 10 seconds or more |
| Battery voltage | 10.5 V or more |
| ECT sensor | OK |
| ECT change since engine stopped | Less than 180°C (356°F) |
| ECT before engine stop | 70°C (158°F) or more |
| Time that MAF is low before engine stop | 70 minutes |
| Accumulated MAF amount before engine stop | 2885 g or more |
| Key-off duration | 30 minutes |
| Key-off duration | 5 hours or more |
| Time after engine start | 10 seconds or more |
| ECT sensor | OK |
| ECT | 70°C (158°F) or more |
| Accumulated MAF amount | 2885 g or more |
| One of the following conditions 1 or 2 is met: | - |
| 1. Duration while engine load is low | 120 seconds or more |
| 2. Duration while engine load is high | 10 seconds or more |
| IAT change | Less than 1°C (2°F) |
| IAT change | Less than 1°C (2°F) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111) |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0111 and other DTCs | A |
| P0111 | B |
|
| ||||
| A | ||
| ||