Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Power Windows do not Operate at All

for Preparation Click here


DESCRIPTION

If all of the door windows do not operate, no power may be supplied to the power window master switch or the power window master switch itself may have a malfunction.

WIRING DIAGRAM


B061926E04


INSPECTION PROCEDURE

1.INSPECT FUSE (PWR, ECU-IG, AM1)
  1. Remove the fuses from the driver side J/B.

  1. Check the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT RELAY (IG1, PWR)


    B061927E01
  1. Remove the relay from the driver side J/B.

  1. Check the resistance of the relay.

    Standard resistance:
    Terminal No.
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω
    (When battery voltage is applied to terminals 1 and 2)



NG
REPLACE RELAY
OK


3.CHECK WIRE HARNESS (TO DRIVER SIDE JUNCTION BLOCK ASSEMBLY)


    B067307E02
  1. Disconnect the 1A, 1H and 1L J/B connectors.

  1. Check the voltage and resistance between each terminal of the wire harness side connector and the body ground.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    1A-1 - Body ground
    Constant
    10 to 14 V

    Standard resistance:
    Terminal No.
    Condition
    Specified Condition
    1L-16 - Body ground
    Constant
    Below 1 Ω
    1H-10 - 1H-29
    Ignition switch ON
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (TO POWER WINDOW REGULATOR MASTER SWITCH)


    B062895E12
  1. Disconnect the D9 master switch connector.

  1. Check the voltage or resistance between each terminal of the wire harness side connector and the body ground.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    D9-6 (B) - Body ground
    Ignition switch ON
    10 to 14 V
    D9-11 (IG) - Body ground

    Standard resistance:
    Terminal No.
    Condition
    Specified Condition
    D9-1 (E) - Body ground
    Constant
    Below 1 Ω



OK
REPLACE POWER WINDOW MASTER SWITCH
NG


5.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - POWER WINDOW MASTER SWITCH)


    B068012E02
  1. Disconnect the 1L and 1K J/B connectors.

  1. Disconnect the D9 master switch connector.

  1. Check the resistance between the wire harness side connectors.

    Standard resistance:
    Terminal No.
    Specified Condition
    1K-20 - D9-6 (B)
    Below 1 Ω
    1L-23 - D9-11 (IG)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY