Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > DATA LIST / ACTIVE TEST

for Preparation Click here



USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  2. Monitor the ECU data by following the prompts on the tester screen.

    HINT:
    Techstream has a "Snapshot" function which records the monitored data.
    Refer to Techstream operator's manual for further details.


DATA LIST

HINT:
Using the Data List displayed by Techstream, you can read the values of the switch, sensor, actuator, etc. without parts removal. Reading the Data List as the first step of troubleshooting is one way to shorten the labor time.

  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the Data List according to the display on the tester.

    Standard (Multiplex network body ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch signal/ ON or OFF
    ON: Key is in ON or START position
    OFF: Key is in OFF or ACC position
    -
    D Door Courtesy SW
    Driver side door courtesy switch signal/ ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Passenger side door courtesy switch signal/ ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -


ACTIVE TEST

HINT:
Performing the Active Test using Techstream allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the Active Test as the first step of troubleshooting is one way to shorten the labor time.
It is possible to display the Data List during the Active Test.

  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the Active Test according to the display on the tester.

    Standard (Multiplex network body ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    IG OFF P/W Permission Output
    Ignition switch OFF power window control permission output
    ON/OFF
    -