Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Manual Up / Down Function does not Operate on Rear LH Only

for Preparation Click here


DESCRIPTION

If the manual UP/DOWN function does not operate, the power window motor, the regulator switch or the wire harness may be malfunctioning.

WIRING DIAGRAM


B062900E16


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (POWER SOURCE)


    B062901E11
  1. Disconnect the P38 regulator switch connector.

  1. Turn the ignition switch ON.

  1. Check the voltage between the terminal 4 of the wire harness side connector and the body ground.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    P38-4 (B) - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR (REGULATOR SWITCH - POWER WINDOW RELAY)
OK


2.INSPECT POWER WINDOW REGULATOR SWITCH (REAR LH)


    B063163
  1. Remove the regulator switch.

  1. Check the resistance between the switch terminals when the switch is operated, as shown in the table below.

    Standard resistance:
    Terminal No.
    Regulator Switch
    Specified Condition
    1 - 2, 3 - 4
    UP
    Below 1 Ω
    1 - 2, 3 - 5
    OFF
    1 - 4, 3 - 5
    DOWN



NG
REPLACE POWER WINDOW REGULATOR SWITCH (REAR LH)
OK


3.CHECK WIRE HARNESS (REGULATOR SWITCH - MOTOR) (REGULATOR SWITCH - BODY GROUND)


    B203393E01
  1. Disconnect the P42 motor connector.

  1. Check the resistance between the wire harness side connectors.

    Standard resistance:
    Terminal No.
    Specified Condition
    P38-1 (D) - P42-2
    Below 1 Ω
    P38-3 (U) - P42-1

  1. Check the resistance between the P38 regulator switch connector and body ground.

    Standard resistance:
    Terminal No.
    Specified Condition
    P38-1 (D) - Body ground
    10 kΩ or higher
    P38-3 (U) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (REAR LH)


    B069021E01
  1. Remove the motor.

  1. Apply battery voltage to connector terminals 1 and 2.

  1. Check that the motor smoothly rotates.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Terminal No.
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (REAR LH)
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (MASTER SWITCH - REGULATOR SWITCH)