Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Manual Up / Down and Auto Down Function does not Operate on Driver Side

for Preparation Click here


DESCRIPTION

If the manual UP/DOWN function does not operate, no power may be supplied to the power window master switch or the power window motor. The power window master switch itself or the wire harness may be malfunctioning.

WIRING DIAGRAM


B069026E03


INSPECTION PROCEDURE

1.INSPECT FUSE (P/W)
  1. Remove the fuse from the driver side J/B.

  1. Check the resistance.

    Standard resistance:
    Below 1 Ω



OK
REPLACE FUSE
NG


2.CHECK WIRE HARNESS (TERMINAL BW)


    B062895E11
  1. Turn the ignition switch ON.

  1. Check the voltage between the terminal of the wire harness side connector and the body ground.

    Standard voltage:
    Terminal No.
    Condition
    Specified Condition
    D9-7 (BW) - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR (P/W FUSE - MASTER SWITCH)
OK


3.INSPECT POWER WINDOW MASTER SWITCH


    B060766
  1. Remove the master switch.

  1. Check the resistance between the terminals of the master switch when the AUTO (driver side) switch is operated, as shown in the table below.

    Standard resistance:
    Terminal No.
    AUTO Switch
    Specified Condition
    1 - 9, 4 - 7
    UP
    Below 1 Ω
    1 - 4 - 9
    OFF
    1 - 4, 7 - 9
    DOWN



NG
REPLACE POWER WINDOW MASTER SWITCH
OK


4.CHECK WIRE HARNESS (MASTER SWITCH - MOTOR) (MASTER SWITCH - BODY GROUND))


    B062894E01
  1. Disconnect the D9 master switch connector.

  1. Disconnect the P40 motor connector.

  1. Check the resistance between the wire harness side connectors.

    Standard resistance:
    Terminal No.
    Specified Condition
    D9-9 (DD) - P40-1 (DOWN)
    Below 1 Ω
    D9-4 (DU) - P40-2 (UP)

  1. Check the resistance between the D9 master switch connector and body ground.

    Standard resistance:
    Terminal No.
    Specified Condition
    D9-9 (DD) - Body ground
    10 kΩ or higher
    D9-4 (DU) - Body ground



    B067306E01
  1. Reference:
    Check operation of the power window motor (driver side).

    1. Remove the motor.

    2. Apply battery voltage to connector terminals 1 and 2.

    3. Check that the motor smoothly rotates.

      NOTICE:
      Do not apply battery voltage to any terminals except terminals 1 and 2.

      Standard:
      Terminal No.
      Specified Condition
      Battery positive (+) → 1
      Battery negative (-) → 2
      Motor gear rotates counterclockwise
      Battery positive (+) → 2
      Battery negative (-) → 1
      Motor gear rotates clockwise



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (DRIVER SIDE)