GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR CLUTCH PULLEY |
![]() |
Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
If the result is not as specified, replace the clutch pulley.
| 2. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the bearing is not rough or worn.
| 3. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using vernier calipers, measure the length of the exposed brushes.
| 4. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check that the generator rotor bearing is not rough or worn.
If necessary, replace the generator rotor assembly.
![]() |
Check the generator rotor for an open circuit.
Using an ohmmeter, measure the resistance between the slip rings.
| Condition | Specified Condition |
| Approx. 20°C (68°F) | 1.5 to 1.9 Ω |
![]() |
Check the rotor for a short to ground.
Using an ohmmeter, measure the resistance between the slip ring and rotor.
| Tester Condition | Specified Condition |
| Slip ring - Rotor | 1 MΩ or higher |
![]() |
Using vernier calipers, measure the slip ring diameter.