Home › ENGINE › 2GR-FE CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR CLUTCH PULLEY


    A128068E01
  1. Using a screwdriver, remove the generator pulley cap.



    A128069E01
  1. Set SST (A) and (B).

    SST
    09820-63021  



    A160961E01
  1. Clamp SST (A) in a vise.

    NOTICE:
    Be sure to fix the flat surface of SST (A) in a vise.



    A135194E01
  1. Place the rotor shaft end into SST (A).



    A135195E01
  1. Fit SST (B) to the clutch pulley.



    A135196E01
  1. Loosen the pulley by turning SST (B) in the direction shown in the illustration.

    NOTICE:
    Hold the generator assembly tightly.

  1. Remove the generator assembly from SST.

  1. Remove the clutch pulley from the rotor shaft.



2. REMOVE GENERATOR REAR END COVER


    A135197
  1. Place the generator assembly on the clutch pulley.



    A128071
  1. Remove the 3 nuts and generator rear end cover.



3. REMOVE GENERATOR TERMINAL INSULATOR


    A128072
  1. Remove the terminal insulator from the generator coil.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A128073
  1. Remove the 2 screws and brush holder from the generator coil.



5. REMOVE GENERATOR COIL ASSEMBLY


    A128074
  1. Remove the 4 bolts.



    A118275E01
  1. Using SST, remove the generator coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A118365E01
  1. Remove the generator washer.



    A118367E01
  1. Remove the generator rotor assembly.