Home › ENGINE › 2GR-FE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE CHARCOAL CANISTER PROTECTOR
  1. Remove the 6 bolts and charcoal canister protector.



2. REMOVE CHARCOAL CANISTER ASSEMBLY


    A162860E01
  1. Disconnect the fuel tank vent hose from the charcoal canister.

    1. Push the connector deep inside.

    2. Pinch portion A.

    3. Pull out the connector.



    A162861
  1. Disconnect the charcoal canister filter sub-assembly from the charcoal canister.

    1. Push the connector deep inside.

    2. Pinch portion A.

    3. Pull out the connector.

  1. Disconnect the vapor pressure sensor connector.

  1. Disconnect the wire harness clamp.

  1. Disconnect the purge line hose from the charcoal canister.



    A162862
  1. Remove the 3 bolts and charcoal canister.