Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1249/49    Open in Stop Light Switch Circuit

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1249/49
When IG1 terminal voltage is 9.5 to 18.5 V, an open circuit of the stop light switch continues for 0.3 sec. or more.
  1. Stop light assembly
  2. Stop light switch circuit

WIRING DIAGRAM


C160967E01


C160969E01


INSPECTION PROCEDURE

1.CHECK STOP LIGHT SWITCH OPERATION
  1. Check that the stop light comes on when the brake pedal is depressed and goes off when the brake pedal is released.

    OK:

    Pedal Condition
    Illumination Condition
    Brake pedal depressed
    ON
    Brake pedal released
    OFF

    HINT:
    Check the stop light bulb as it may have burnt out.



NG
Go to step 4
OK


2.INSPECT SKID CONTROL ECU (STP1 TERMINAL)
  1. Disconnect the skid control ECU connector.



    G024767E58
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S3-27 (STP1) - Body ground
    Brake pedal depressed
    8 to 14 V
    S3-27 (STP1) - Body ground
    Brake pedal released
    Below 1 V



NG
Go to step 5
OK


3.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to the ON position.

  1. Are the same DTCs detected?

    Result:

    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here).



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A

REPLACE BRAKE ACTUATOR ASSEMBLY 

4.INSPECT STOP LIGHT SWITCH
  1. Disconnect the stop light switch assembly connector.



    C146625E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Switch condition
    Specified condition
    1 - 2
    Switch pin free
    Below 1 Ω
    1 - 2
    Switch pin pushed in
    10 kΩ or higher



NG
REPLACE STOP LIGHT SWITCH
OK


5.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - SKID CONTROL ECU)
  1. Disconnect the stop light switch connector and skid control ECU connector.



    G026188E08
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-27 (STP1) - S12-1 (STP)
    Below 1 Ω

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY