Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1251/51    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1251/51
When either of the following is detected:
  1. Actuator pump motor does not operate properly.
  2. Open in actuator pump motor circuit continues for at least 2 sec.
  1. Brake actuator assembly (Ground circuit)
  2. Brake actuator assembly (Motor circuit)

WIRING DIAGRAM


F045122E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY)
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on Techstream.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Motor Relay
    ABS motor relay
    Relay ON / OFF
    Operation of motor (clicking sound) can be heard

  1. Check the operation sound of the ABS motor individually when operating it with Techstream.

    OK:
    The operation sound of the ABS motor should be heard.

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here).



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

2.INSPECT SKID CONTROL ECU (GND2 TERMINAL)
  1. Disconnect the skid control ECU connector.



    G024767E59
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-1 (GND2) - Body ground
    Below 1 Ω

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY