VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light Remains ON |

| 1.CHECK DTC |
Is DTC output for ABS?
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check the ECU connector's connecting condition.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-46 (IG1) - S3-32 (GND1) | 10 to 14 V |
| S3-46 (IG1) - S3-1 (GND2) | 10 to 14 V |
|
| ||||
| OK | |
| 5.CHECK ABS WARNING LIGHT |
WHEN USING TECHSTREAM:
Connect Techstream to the DLC3 and start the engine.
Select the item "ABS Warning Light" in the Active Test and operate the ABS warning light on Techstream.
Check that "ON" and "OFF" of the ABS warning light can be shown on the combination meter by Techstream.
WHEN NOT USING TECHSTREAM:
![]() |
Turn the ignition switch off and disconnect the connector from the skid control ECU.
Ground the terminal WA of the skid control ECU.
Turn the ignition switch to the ON position.
Check that the ABS warning light goes off.
|
| ||||
| NG | ||
| ||
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND) |
Disconnect the skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-1 (GND2) - Body ground | Below 1 Ω |
| S3-32 (GND1) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||