Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1210/36    Zero Point Calibration of Yaw Rate Sensor Undone

DTC    C1336/39    Zero Point Calibration of Acceleration Sensor Undone

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate sensor via CAN communication system.
Yaw rate sensor has the built-in deceleration sensor.
If there is trouble in the bus lines between the yaw rate and deceleration sensor and CAN communication system, the DTC U0123/62 (yaw rate sensor communication trouble) and U0124/95 (deceleration sensor communication trouble) are output.
The DTC is also output when the calibration has not been completed.

DTC Code
DTC Detection Condition
Trouble Area
C1210/36
Zero point calibration of yaw rate sensor undone.
  1. Yaw rate and deceleration sensor
  2. Zero point calibration undone
C1336/39
When either of the following is detected:
  1. The vehicle runs in the normal mode with zero point calibration undone.
  2. After the zero point has been obtained, the zero point voltage of the sensor is not between 2.38 and 2.62 V.
  1. Yaw rate and deceleration sensor
  2. Zero point calibration undone

WIRING DIAGRAM


C132917E08


INSPECTION PROCEDURE

HINT:
When U0073/94, U0100/65, U0123/62, U0124/95 or U0126/63 are output accompanied with C1210/36 or C1336/39, inspect and repair the trouble areas indicated by U0073/94, U0100/65, U0123/62, U0124/95 or U0126/63 first.

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR
  1. Perform the zero point calibration of the yaw rate and deceleration sensor (Click here).


NEXT


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to the ON position.

  1. Are the same DTCs recorded (Click here).

    Result:

    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A


3.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and deceleration sensor has been installed properly (Click here).

    NOTICE:
    When replacing the yaw rate and deceleration sensor, perform zero point calibration (Click here).



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY
OK

REPLACE YAW RATE AND DECELERATION SENSOR