Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control buzzer sounds and SLIP indicator blinking during VSC operation.

WIRING DIAGRAM


C132930E07


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER)
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Select the item "Buzzer" in the Active Test and operate the skid control buzzer on Techstream.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON / OFF
    Buzzer can be heard

  1. Check that skid control buzzer sounds by operating with Techstream.

    OK:
    The skid control buzzer sounds in accordance with operation of Techstream.



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

2.INSPECT SKID CONTROL BUZZER
  1. Disconnect the skid control buzzer connector.



    F002192E10
  1. Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer connector, and check that the buzzer sounds.

    OK:
    The skid control buzzer sound should be heard.



NG
REPLACE SKID CONTROL BUZZER
OK


3.CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)
  1. Disconnect the skid control buzzer connector and the skid control ECU connector.



    G026280E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-30 (BZ) - V6-1 (BZ)
    Below 1 Ω

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-30 (BZ) - Body ground
    10 kΩ or higher

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY