Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1241/41    Low Battery Positive Voltage

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1241/41
When any of the following is detected:
  1. At a vehicle speed of 3 km/h (2mph) or more, the IG1 terminal voltage is 9.5 V or less for 10 sec. or more.
  2. With the IG1 terminal voltage 9.5 V or less, the vehicle speed sensor power supply decreases for 60 sec. or more.
  3. When the solenoid relay remains ON and the IG1 terminal voltage is 9.5 V or less, the relay contact is open for 0.2 sec. or more.
  4. While the motor fail safe relay is ON after motor relay ON, the IG1 terminal voltage is 9.5 V or less and the actuator pump drive motor is OFF for 0.1 sec. or more.
  1. Battery
  2. Charging system
  3. Power source circuit

WIRING DIAGRAM


F045116E06


INSPECTION PROCEDURE

1.INSPECT ECU-IG FUSE
  1. Remove the ECU-IG fuse from the driver side J/B.



    F045093E09
  1. Check continuity of the ECU-IG fuse.

    Standard resistance:
    Tester Connection
    Specified condition
    ECU-IG Fuse
    Below 1 Ω



NG
REPLACE ECU-IG FUSE
OK


2.CHECK BATTERY
  1. Check the positive battery voltage.

    Standard voltage:
    11 to 14 V



NG
CHECK OR REPLACE CHARGING SYSTEM OR BATTERY
OK


3.INSPECT SKID CONTROL ECU (IG1 TERMINAL)
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.



    G024767E42
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    S3-46 (IG1) - S3-32 (GND1)
    10 to 14 V
    S3-46 (IG1) - S3-1 (GND2)
    10 to 14 V

    NOTICE:
    When replacing the brake actuator assembly, perform zero point calibration (Click here).



NG
Go to step 4
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

4.INSPECT SKID CONTROL ECU (GND TERMINAL)
  1. Disconnect the skid control ECU connector.



    G024767E43
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-32 (GND1) - Body ground
    Below 1 Ω
    S3-1 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)