Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1217    Rear Door ECU LH Communication Stop

for Preparation Click here


DESCRIPTION

DTC B1217 is output when communication between the power slide door ECU LH and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1217
RL-DOOR ECU communication stops
  1. Power slide door ECU LH
  2. Wire harness

WIRING DIAGRAM


C160427E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - BATTERY)


    C160730E02
  1. Disconnect the P25 and P26 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    P25-10 (ECUB) - Body ground
    Always
    11 to 14 V
    P26-2 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - GROUND)


    C160411E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P26-8 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160731E02
  1. Disconnect the G4 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P25-22 (MPX1) - G4-3 (MPD1)
    Always
    Below 1 Ω
    P25-22 (MPX1) - G4-12 (MPD2)
    Always
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND POWER SLIDE DOOR ECU LH

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE POWER SLIDE DOOR ECU LH