Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1281    Airbag ECU Communication Stop

for Preparation Click here


DESCRIPTION

DTC B1281 is output when communication between the airbag ECU and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1281
Airbag ECU communication stops
  1. Airbag sensor assembly
  2. Wire harness

WIRING DIAGRAM


C160430E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIRBAG SENSOR ASSEMBLY - BATTERY)


    C160414E01
  1. Disconnect the A21 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A21-5 (IG2) - Body ground
    Ignition switch: ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (AIRBAG SENSOR ASSEMBLY - GROUND)


    C160414E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A21-27 (E1) - Body ground
    Always
    Below 1 Ω
    A21-28 (E2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160736E01
  1. Disconnect the 1E and A9 ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A21-22 (MPX2) - 1E-7
    Always
    Below 1 Ω
    A21-24 (MPX1) - A9-3 (MPX-) (*1), A9-5 (MPX-) (*2)
    Always
    Below 1 Ω

    HINT:
    *1: for Automatic A/C
    *2: for Manual A/C

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND AIRBAG SENSOR ASSEMBLY

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE AIRBAG SENSOR ASSEMBLY