Home › BODY › MIRROR › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/o Memory)


    B059702E04
  1. The L side of the left / right adjustment switch:
    Inspect the mirror switch resistance.

    Standard resistance (Left side):
    Terminal No.
    Switch Position
    Specified Condition
    -
    OFF
    10 kΩ or higher
    4 - 8
    UP
    Below 1 Ω
    6 - 7
    4 - 7
    DOWN
    Below 1 Ω
    6 - 8
    5 - 8
    LEFT
    Below 1 Ω
    6 - 7
    5 - 7
    RIGHT
    Below 1 Ω
    6 - 8

    If the result is not as specified, replace the switch assembly.

  1. The R side of the left / right adjustment switch:
    Inspect the mirror switch resistance.

    Standard resistance (Right side):
    Terminal No.
    Switch Position
    Specified Condition
    -
    OFF
    10 kΩ or higher
    3 - 8
    UP
    Below 1 Ω
    6 - 7
    3 - 7
    DOWN
    Below 1 Ω
    6 - 8
    2 - 8
    LEFT
    Below 1 Ω
    6 - 7
    2 - 7
    RIGHT
    Below 1 Ω
    6 - 8

    If the result is not as specified, replace the switch assembly.



2. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/ Memory)


    B112557E02
  1. Remove the outer mirror control switch.

  1. Measure the resistance according to the value(s) in the table below when the switch is operated.

    Resistance:
    Tester Connection
    Switch Position
    Specified Condition
    2 - 3
    OFF
    10 kΩ or higher
    UP + L or R (*1)
    80 to 120 Ω
    DOWN + L or R (*1)
    450 to 490 Ω
    LEFT + L or R (*1)
    780 to 820 Ω
    RIGHT + L or R (*1)
    230 to 270 Ω
    1 - 2
    L
    90 to 110Ω
    R
    10 Ω or less
    4 - 7
    6 - 8
    Driving position (Unfold)
    Below 1Ω
    4 - 8
    6 - 6
    Retract position (Fold)
    Below 1Ω

    *1: The L or R of the left / right adjustment switch.