Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR AND BRACKET

REAR WIPER MOTOR AND BRACKET > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
  1. Install the rear wiper motor assembly with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL REAR WIPER ARM


    E058837E19
  1. Scrape off the serration part of the wiper arm with a round file or equivalent.

  1. Clean the rear wiper pivot serration with a brush.



    I035787E01
  1. Stop the rear wiper motor assembly to the automatic stop position. Install the rear wiper arm to the position as shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Install the rear wiper arm head cap.