Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR AND BRACKET

REAR WIPER MOTOR AND BRACKET > INSPECTION

for Preparation Click here



1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY


  1. Operation check



      E065756E01
    1. Connect the battery (+) to the terminal 1 (+B) of the connector, the battery (-) to the terminal 3 (LS) of the connector and wire harness terminal of the rear wiper motor and bracket assembly, then check that the rear wiper motor and bracket operate.



  1. Automatic Stop Position Operation Check



      E065755E01
    1. Connect the battery (+) to the terminal 1 (+B) of the connector, the battery (-) to the terminal 3 (LS) of the connector and wire harness terminal of the rear wiper motor and bracket assembly. With the motor being rotated disconnect the terminal 3 (LS) from the battery (-), then check that the wiper motor stops automatically to the automatic stop position.