Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR AND BRACKET

REAR WIPER MOTOR AND BRACKET > REMOVAL

for Preparation Click here



1. REMOVE REAR WIPER ARM
  1. Remove the rear wiper arm head cap from the rear wiper arm.

  1. Remove the nut and the rear wiper arm.



2. REMOVE BACK DOOR GARNISH CENTER


    B069688E01
  1. Using a clip remover, disengage the 5 clips and remove the garnish center.



3. REMOVE BACK DOOR SIDE GARNISH LH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



4. REMOVE POWER BACK DOOR ROD


5. REMOVE BACK DOOR SIDE GARNISH RH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



6. REMOVE BACK DOOR STRAP COVER


    B067784E01
  1. Using a screwdriver, disengage the claws and remove the strap cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and strap.



7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B067783E01
  1. Using the screwdriver, disengage the 14 clips and remove the trim board.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the service hole cover from the trim board.



8. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY


    I035795E02
  1. Remove the 3 bolts.

  1. Disconnect the connector, and remove the rear wiper motor assembly.