Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY


  1. Continuity Check



      E065758E01
    1. Check the continuity between each of the terminals of the connector.

      Standard:
      Front Wiper Switch:
      Switch position
      Tester connection
      Specified condition
      MIST
      7 (+1) - 17 (+B)
      Continuity
      OFF
      7 (+1) - 16 (+S),
      7 (+1) - 17 (+B)
      No continuity
      INT
      7 (+1) - 16 (+S)
      Continuity
      LO
      7 (+1) - 17 (+B)
      Continuity
      HI
      8 (+2) - 17 (+B)
      Continuity
      Front Washer Switch:
      Switch position
      Tester connection
      Specified condition
      OFF
      2 (EW) - 11 (WF)
      No continuity
      ON
      2 (EW) - 11 (WF)
      Continuity
      Rear Wiper Switch:
      Switch position
      Tester connection
      Specified condition
      OFF
      2 (EW) - 13 (C1R),
      2 (EW) - 10 (+1R)
      No continuity
      INT
      2 (EW) - 13 (C1R)
      Continuity
      ON
      2 (EW) - 10 (+1R)
      Continuity
      Rear Washer Switch:
      Switch position
      Tester connection
      Specified condition
      OFF
      2 (EW) - 12 (WR)
      No continuity
      ON
      (Rear wiper switch OFF side)
      2 (EW) - 12 (WR)
      Continuity
      ON
      (Rear wiper switch ON side)
      2 (EW) - 12 (WR),
      2 (EW) - 10 (+1R)
      Continuity



  1. Intermittent Operation Check

    1. Connect the voltmeter (+) terminal to the terminal 7 (+1) of the connector, the voltmeter (-) terminal to the terminal 2 (EW) of the connector.

    2. Connect the battery (+) to the terminal 17 (+B) of the connector, the battery (-) to the terminal 2 (EW) and the terminal 16 (+S) of the connector.

    3. Turn the wiper switch into the INT position.

    4. Connect the battery (+) to the terminal 16 (+S) of the connector for 5 seconds.



    5. Connect the battery (-) to the terminal 16 (+S) of the connector. Operate the intermittent wiper relay and check voltage between the terminal 7 (+1) and the terminal 2 (EW).


      E056399E22



  1. Operation Check (Front Wiper)

    1. Turn the wiper switch into the OFF position.

    2. Connect the battery (+) to the terminal 17 (+B) of the connector, the battery (-) to the terminal 16 (+S) and 2 (EW) of the connector.



    3. I032848E02
    4. Connect the voltmeter (+) terminal to the terminal 7 (+1) of the connector, the voltmeter (-) terminal to the terminal 2 (EW) of the connector. Turn the washer switch ON and OFF and check voltage between the terminal 7 (+1) and the terminal 2 (EW).