Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)

REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR NO. 2 SEAT ASSEMBLY
  1. Lock the seat leg rear to the floor striker.

  1. Lock the seat leg front to the floor striker.



    B126838E01
  1. Install the rear No. 2 seat assembly with the 8 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order shown in the illustration.

  1. Connect the connector.



2. INSTALL NO. 2 SEAT HINGE COVER


3. INSTALL REAR SEAT LEG SIDE GARNISH SUB-ASSEMBLY
  1. Install 4 new clips to the rear seat leg side garnish sub-assembly.



    B126836
  1. Engage the 4 clips and install the rear seat leg side garnish sub-assembly.



4. INSTALL REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY
  1. Install 9 new clips to the rear No. 2 seat leg side garnish sub-assembly.



    B126835
  1. Engage the 4clips and install the rear No. 2 seat leg side garnish sub-assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. CHECK POWER REAR NO. 2 SEAT WITH STOWING FUNCTION


  1. Check the basic functions.



    1. Operate the fold seat switch and power rear No.2 seat switch and check to make sure each seat function works:


      B129719E01

      1. Folding-down operation
      2. Stowing operation
      3. Return operation
      4. Reclining operation



7. PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal.