Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL STEERING COLUMN ASSEMBLY


    F045001
  1. Install the steering column assembly with the 3 bolts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

  1. Connect the connectors.

  1. Connect the wire harness clamps to the steering column tube.



2. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY


    D029986E02
  1. Align the matchmarks on the intermediate shaft assembly and steering gear assembly.

  1. Install the steering intermediate shaft assembly with the bolt.

    Torque:
    36 N*m{ 370 kgf*cm , 27 ft.*lbf }



    D030704E02
  1. Install the dust cover to the hole cover. Check that the 3 clips of the dust cover are securely fitted into the groove on the hole cover.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    If it is not in the neutral position, the pin of the turn signal switch may snap.



    C111133
  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

  1. Connect the connectors to the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



5. INSTALL STEERING COLUMN COVER


6. CENTER SPIRAL CABLE
  1. Check that the ignition switch is off.

  1. Check that the battery negative (-) terminal is disconnected.

    CAUTION:
    After removing the terminal, wait for at least 90 seconds before starting the operation.



    H042773
  1. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.



    H042774E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not turn the spiral cable by the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



7. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connector.



8. INSTALL HORN BUTTON ASSEMBLY


    H042675
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



9. INSTALL STEERING WHEEL COVER LOWER NO.3
  1. Install the steering wheel No.3 cover lower.



10. INSTALL STEERING WHEEL COVER LOWER NO.2
  1. Install the steering wheel No.2 cover lower.



11. INSPECT STEERING WHEEL CENTER POINT


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
  2. Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.



13. INSPECT HORN BUTTON ASSEMBLY


    H042649
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



14. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).