STEERING COLUMN ASSEMBLY > DISASSEMBLY |
| 1. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the steering intermediate shaft assembly and main shaft.
Remove the bolt and steering intermediate shaft assembly.
| 2. REMOVE KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System) |
| 3. REMOVE TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System) |
![]() |
Widen the claw hanging onto the upper bracket by approx. 1.0 mm (0.039 in.) using a screwdriver.
Pull the transponder key amplifier toward the rear of the vehicle with the claw open.
| 4. REMOVE STEERING COLUMN BRACKET ASSEMBLY UPPER |
![]() |
Using a centering punch, mark the center of the 2 tapered-head bolts.
Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole into the heads of the 2 bolts.
Using a screw extractor, remove the 2 bolts and steering column upper w/ switch bracket assembly.
| 5. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY |
![]() |
Place the ignition switch lock cylinder assembly in the ACC position.
Push down the stop pin with a screwdriver, and pull out the cylinder assembly.
| 6. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY |
![]() |
Disconnect the un-lock warning switch assembly connector from the ignition or starter switch assembly.
Remove the un-lock warning switch assembly by pushing up the center part and releasing the 2 claws.
![]() |
Disengage the secondary locking device.
Using a screwdriver, disengage the locking lug of terminals 1 and 2, and pull the terminals out from the rear side of the un-lock warning switch assembly.
| 7. REMOVE KEY INTER LOCK SOLENOID |
Remove the 2 screws and solenoid from the steering column bracket assembly.
| 8. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY |
Remove the 2 screws and ignition or starter switch assembly from the steering column bracket assembly UPR.