Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK VVT SENSOR OUTPUT VOLTAGE



G035613E30

  1. Turn the ignition switch to ON.

  1. Check the voltage between the specified terminal and body ground.

    Standard voltage:
    Tester Connection
    Position
    Specified Condition
    E9-23 (VC) - Body ground
    Ignition switch ON
    5 V

  1. While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the High range and Low range shown in the table below.

    Standard voltage:

    Sensor Position
    Terminal No.
    Voltage (High)
    Voltage (Low)
    Bank 1 (Intake side)
    VV1+ (E11-19) - VV1- (E11-29)
    3.75 to 4.50 V
    0.50 to 1.25 V
    Bank 2 (Intake side)
    VV2+ (E11-18) - VV2- (E11-28)
    3.75 to 4.50 V
    0.50 to 1.25 V
    Bank 1 (Exhaust side)
    EV1+ (E11-25) - EV1- (E11-24)
    3.75 to 4.50 V
    0.50 to 1.25 V
    Bank 2 (Exhaust side)
    EV2+ (E11-23) - EV2- (E11-22)
    3.75 to 4.50 V
    0.50 to 1.25 V