Home › DRIVE LINE › MF2A TRANSFER › BEARING RETAINER OIL SEAL

BEARING RETAINER OIL SEAL > REMOVAL

for Preparation Click here



1. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. REMOVE NO. 1 TRANSFER CASE PLUG


    C082977E01
  1. Remove the No. 1 transfer case plug.

  1. Remove the No. 1 gasket from the transfer case No. 1 plug.



3. REMOVE TRANSFER DRAIN PLUG
  1. Remove the transfer drain plug, gasket and bleed the drain transfer oil.



4. REMOVE FRONT WHEEL


5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:
(Click here)



6. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL


    C083628E02
  1. Using SST, remove the transfer RH bearing retainer oil seal.

    SST
    09308-00010  

    NOTICE:
    Do not damage the oil-seal-fitted surface of the case.