Home › DRIVE LINE › MF2A PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 4WD)

PROPELLER SHAFT ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST PIPE ASSEMBLY
  1. Remove exhaust pipe assembly (Click here).



2. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY


    F040503E01
  1. Depress the brake pedal and hold it down.

  1. Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts a half turn.

    HINT:
    Place a cloth in the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.



    C092265E01
  1. Put matchmarks on both the flanges.

  1. Remove the 4 nuts, bolts and washers.



    C083005
  1. Remove the 4 bolts, 2 adjusting shims and propeller shaft w/ center bearing shaft assembly.

    NOTICE:
    1. When removing the propeller shaft, do not apply excessive force to the universal joint.
    2. During and after the removal of the propeller shaft, keep the universal joint angle straight (within 15 degrees).
    3. Be careful not to damage the oil seal.



    G024034E01
  1. Insert SST(s) in the transfer extension housing to prevent oil leakage.

    SST
    09325-20010  

    NOTICE:
    Be careful not to damage the oil seal.