PROPELLER SHAFT ASSEMBLY (for 4WD) > REASSEMBLY |
| 1. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO.1 |
![]() |
Set the center support bearing assembly No. 1 (front) to the intermediate shaft, as shown in the illustration.
Install a new washer to the intermediate shaft.
![]() |
Align the matchmarks on the front flange and shaft, and place the flange on the shaft.
![]() |
Using SST(s) to hold the front flange, press the center support bearing assembly No. 1 (front) into the position by tightening down with a new nut and plate washer.
Loosen the nut.
Torque the nut again.
Using a chisel and a hammer, stake the nut.
| 2. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO.1 |
![]() |
Set the center support bearing assembly No. 1 (rear) on the shaft, as shown in the illustration.
Install a new washer to the shaft.
![]() |
Align the matchmarks on the rear flange and shaft, and place the flange on the shaft.
![]() |
Using SST(s) to hold the front flange, press the center support bearing assembly No. 1 (rear) into the position by tightening down with a new nut and plate washer.
Loosen the nut.
Torque the nut again.
Using a chisel and a hammer, stake the nut.
| 3. INSTALL INTERMEDIATE SHAFT |
![]() |
Align the matchmarks on the intermediate shaft and rear propeller shaft assembly rear, then install the 2 washers and 6 bolts.
Using a hexagon wrench (6 mm), loosely tighten the 6 bolts.
| 4. INSTALL PROPELLER SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the propeller shaft assembly flange and front flange, and connect the shaft with the 4 bolts, washers and nuts.
Check that each joint of the propeller shaft is facing in the correct direction, as shown in the illustration below.
