Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REMOVAL

for Preparation Click here


HINT:
Replace the RH side using the same procedures as for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT AXLE SHAFT LH NUT


    F040146E09
  1. Using SST and a hammer, unstake the staked part of the axle hub LH nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While applying the brakes, remove the lock axle hub LH nut.



3. SEPARATE SPEED SENSOR FRONT LH


    C083022
  1. Remove the bolt and clip, and separate the sensor wire and hose from the shock absorber.

    NOTICE:
    Be careful not to damage the speed sensor.



    F040147
  1. Remove the bolt, and separate the speed sensor from LH from the steering knuckle.

    NOTICE:
    Prevent foreign matter from adhering to the speed sensor.



4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C067088
  1. Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.

    NOTICE:
    Use a string or other device to keep the brake caliper from hanging down.



5. REMOVE FRONT DISC


6. SEPARATE TIE ROD END SUB-ASSEMBLY LH


    F045060E06
  1. Remove the cotter pin and nut.

  1. Using SST, separate the tie rod end from the steering knuckle.

    SST
    09628-62011  



7. SEPARATE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO.1 LH


    F040142
  1. Remove the bolt and 2 nuts, and separate the No. 1 front suspension arm sub-assembly lower from the lower ball joint.



8. REMOVE FRONT AXLE ASSEMBLY LH


    D027403
  1. Using a plastic hammer, separate the front drive shaft assembly LH from the front axle hub sub-assembly LH.

    NOTICE:
    Be careful not to damage the boot and ABS speed sensor rotor.



    C083023
  1. Remove the 2 bolts, nuts and steering knuckle LH with the front axle nub sub-assembly LH.