Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > DISASSEMBLY

for Preparation Click here



1. REMOVE LOWER BALL JOINT ASSEMBLY FRONT LH


    F040153E02
  1. Remove the cotter pin and nut.

  1. Using SST(s), remove the lower ball joint assembly front LH.

    SST
    09628-62011  



2. REMOVE FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH


    F040154
  1. Using a screwdriver, remove the bearing dust deflector NO. 1 LH.



3. REMOVE FRONT AXLE HUB LH HOLE SNAP RING


    F045465
  1. Using snap ring pliers, remove the front axle hub LH hole snap ring.



4. REMOVE FRONT AXLE ASSEMBLY LH


    F040156E05
  1. Using SST(s), remove the front axle hub sub-assembly LH.

    SST
    09520-00031  



    F002261E03
  1. Using SST(s) and a press, remove the bearing inner race (outside) from the front axle hub sub-assembly LH.

    SST
    09950-00020  
    09950-60010   (09951-00430)
    09950-70010   (09951-07100)



5. REMOVE DISC BRAKE DUST COVER FRONT LH
  1. Using a torx wrench (T30), remove the 4 bolts and disc brake dust cover front LH.

    HINT:
    Torx is a registered trademark of Textron Inc.



6. REMOVE FRONT AXLE HUB LH BEARING


    F040230E05
  1. Place the bearing inner race (outside) on the front axle hub LH bearing.

  1. Using SST(s) and a press, press the front axle hub LH bearing until it contacts the SST(s).

    SST
    09527-17011  
    09950-60010   (09951-00600)
    09950-70010   (09951-07100)



    F011547E03
  1. Using a spanner to make the steering knuckle LH horizontal, fix it to the V block, as shown in the illustration.

    NOTICE:
    Be sure the steering knuckle is horizontally positioned.

  1. Using SST(s) and a press, remove the front axle hub LH bearing.

    SST
    09950-60010   (09951-00600)
    09950-70010   (09951-07100)