Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT AXLE HUB LH BEARING


    F040231E07
  1. Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.

    SST
    09950-60020   (09951-00810)
    09950-70010   (09951-07100)



2. INSTALL DISC BRAKE DUST COVER FRONT LH
  1. Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.

    Torque:
    8.3 N*m{ 85 kgf*cm , 74 in.*lbf }

    HINT:
    Torx is a registered trademark of Textron Inc.



3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH


    F040157E02
  1. Using SST(s), and a press, install the front axle hub sub-assembly LH.

    SST
    09608-32010  
    09950-60020   (09951-00810)
    09950-70010   (09951-07100)



4. INSTALL FRONT AXLE HUB LH HOLE SNAP RING


    F045465
  1. Using snap ring pliers, install a new front axle hub LH hole snap ring.



5. INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH


    F045054E03
  1. Using SST(s) and a hammer, install the bearing dust deflector No. 1 LH.

    SST
    09316-60011   (09316-00011, 09316-00031)
    09608-32010  

    HINT:
    Align the hole for the speed sensor in the bearing dust deflector No. 1 LH with the steering knuckle.



6. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH
  1. Install the lower ball joint assembly front LH and tighten the nut.

    Torque:
    123 N*m{ 1,250 kgf*cm , 91 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.