Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT AXLE HUB BEARING BACKLASH


    F040163E03
  1. Using a dial gauge, check for backlash near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    If backlash exceeds the maximum, replace the bearing.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



2. INSPECT FRONT AXLE HUB BEARING DEVIATION


    F040164E02
  1. Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.

    Maximum:
    0.05 mm (0.0020 in.)

    If deviation exceeds the maximum, replace the axle hub.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.