Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING (for 4WD)

REAR AXLE HUB AND BEARING (for 4WD) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR AXLE HUB BEARING BACKLASH


    C083015E04
  1. Using a dial gauge, check for backlash near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



2. INSPECT REAR AXLE HUB BEARING DEVIATION


    C083016E04
  1. Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.