PURGE VALVE > INSPECTION |
| 1. INSPECT PURGE VSV |
![]() |
Measure the resistance of the purge VSV.
| Tester Connection | Specified Condition |
| 1 - 2 | 23 to 26 Ω at 20°C (68°F) |
| 1 - Body ground 2 - Body ground | 10 MΩ or higher |
Check the operation of the purge VSV.
![]() |
Check that air does not flow from port E to port F.
![]() |
Apply battery voltage across the terminals.
Check that air flows from port E to port F.
If the result is not as specified, replace the purge VSV.